Troubleshooting - Furrion VISION S User Manual

Troubleshooting

Problem
Monitor won't turn on (no
blue LED)
Wireless camera(s) and
monitor won't pair
Intermittent / weak
signal icon appears
Blurry images on the
monitor
Images too dark / bright
on the monitor
CCD-0005559 Rev: 04-29-22
Check the power cable is connected.
Check that the power supply has 12-24V DC output.
Check all fuses and breakers (including fuses in the cigarette power
adapter and fuse box).
Power off and on again to reset.
Furrion monitor / rearview mirror can only pair with Furrion cameras.
Pairing with products from other manufacturers is not supported.
Check if the camera is receiving power.
Ensure that the fuse on the connected power line provides
−
additional 1A fusing current for the camera.
Ensure proper cable isolation for all bare ends to avoid short-
−
circuit.
Make sure to hold the camera pairing button for 2 seconds.
Check if the camera antenna is fitted and secured correctly - it
should be vertical.
Large dense objects could be obscuring the signal. If possible, move
the objects.
Interference from electrical appliances may be affecting the wireless
signal. Turn off the appliances when using the system.
Interference from overhead power lines may be affecting the signal.
Try unpairing and pairing again.
Remove the protective film from the camera lens upon
completion of installation.
The camera lens may be dirty. Wipe them with a piece of soft and
clean cloth.
Some adverse weather conditions such as heavy fog, rain,
floating dust or mud splashes may either partially or entirely
block the camera view. Clean the camera lens immediately after
driving to a safe place.
Adjust the brightness and contrast settings.
The image may be too bright when the camera lens are facing
towards a direct light source. This is not a malfunction.
- 34 -
Solution