Troubleshooting - Furrion FOS07TASR User Manual

Troubleshooting

Problem
Monitor won't turn on (no
blue LED)
Wireless camera(s) and
monitor won't pair
Intermittent / weak
signal icon appears
Blurry images on the
monitor
Images too dark / bright
on the monitor
Night vision is poor or
does not function
34
Check the power cable is connected.
Check that the power supply has 12-24V DC output.
Check all fuses and breakers (including fuses in the cigarette power
adapter and fuse box).
Power off and on again to reset.
Furrion monitor / rearview mirror can only pair with Furrion cameras.
Pairing with products from other manufacturers is not supported.
Check if the camera is receiving power.
− Ensure that the fuse on the connected power line provides
additional 1A fusing current for the camera.
− Ensure proper cable isolation for all bare ends to avoid short-
circuit.
Make sure to hold the camera pairing button for 2 seconds.
Check if the camera antenna is fitted and secured correctly - it
should be vertical.
Large dense objects could be obscuring the signal. If possible, move
the objects.
Interference from electrical appliances may be affecting the wireless
signal. Turn off the appliances when using the system.
Interference from overhead power lines may be affecting the signal.
Try unpairing and pairing again.
Remove the protective film from the camera lens upon completion of
installation.
The camera lens may be dirty. Wipe them with a piece of soft and
clean cloth.
Some adverse weather conditions such as heavy fog, rain, floating
dust or mud splashes may either partially or entirely block the camera
view. Clean the camera lens immediately after driving to a safe place.
Adjust the brightness and contrast settings.
The image may be too bright when the camera lens are facing
towards a direct light source. This is not a malfunction.
The light sensor on the camera may be dirty or obstructed. Clean the
light sensor or remove obstacles.
If the ambient light is too strong, the night vision function may not
engage. This is not a malfunction.
Ensure that the camera is installed at least 2 inches away from
marker lights.
Solution