Beko BEEPI 090 User Manual page 32

4 Installation
If you will install the unit on the ground or on a
concrete mounting platform, do the following:
1. Mark the positions for four expansion bolts
based on dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Place a nut on the end of each expansion bolt.
4. Hammer expansion bolts into the pre-drilled
holes.
5. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
6. Put washer on each expansion bolt, then
replace the nuts.
7. Using a wrench, tighten each nut until snug.
A WARNING! When drilling into
concrete, eye
recommended at all times.
If you will install the unit on a wall-mounted
bracket, do the following:
CAUTION! Make sure that the
wall is made of solid brick,
A
concrete, or of similarly strong
material. The wall must be able
to support at least four times the
weight of the unit.
1. Mark the position of bracket holes based on
dimensions chart.
2. Pre-drill the holes for the expansion bolts.
3. Place a washer and nut on the end of each
expansion bolt.
4. Thread expansion bolts through holes in
mounting brackets, put mounting brackets in
position, and hammer expansion bolts into the
wall.
5. Check that the mounting brackets are level.
32 / 120 EN
6. Carefully lift unit and place its mounting feet on
brackets.
7. Bolt the unit firmly to the brackets.
8. If allowed, install the unit with rubber gaskets to
reduce vibrations and noise.
Step 4: Connect signal and power cables
The outside unit's terminal block is protected by
an electrical wiring cover on the side of the unit.
A comprehensive wiring diagram is printed on the
inside of the wiring cover.
protection is
1. Prepare the cable for connection: Please
choose the right cable refer to "Cable types" in
page 26.
C
C
• Using wire strippers, strip the rubber jacket
from both ends of cable to reveal about 40mm
(1.57in) of the wires inside.
• Strip the insulation from the ends of the wires.
• Using a wire crimper, crimp u-lugs on the ends
of the wires.
A WARNING! Before performing
any electrical or wiring work, turn
off the main power to the system.
The size of the power supply
cable, signal cable, fuse, and
switch needed is determined
by the maximum current of the
unit. The maximum current is
indicated on the nameplate
located on the side panel of the
unit.
In North America, please choose
the right cable size according to
the minimum circuit ampacity
indicated on the nameplate of
the unit.
Split Type Air Conditioner / User Manual