Page 1
What’s In The Box Please inspect the contents of your shipped package to ensure you have received everything that is listed below. Bush Flycam swivel Allen Key (4mm, 3/16mm, 3mm) Ronin Adapter Plate All rights reserved. No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means, electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permitted by the applicable copyright statutes or in writing by the Publisher.
Page 2
Loosen the bolts of the Flycam swivel with the help of a 4mm Allen key and insert the rod. • Tighten the bolt of the Flycam swivel with a 4mm Allen Key. • After tightening the bolt, attach the end cap to the rod.
Page 3
• Remove all the screw bush as shown in the image. • Then place the handlebars one by one on the Ronin plate. • Place the top plate of the next Flycam swivel on top, As shown in the image.
Page 4
• After inserting into the swivel, insert the handle. • Tighten the handle properly, as shown in the image. • Remove the bolts from the top plate of the Flycam swivel with the help of a 4mm Allen Key.
Page 5
• Insert the Flycam swivel by sliding it onto the DJI Ronin gimbal (Not-Included). lock the gimbal with the locking lever of the swivel plate. • The Flycam swivel is now properly attached with DJI Ronin Gimbal (Not-Included). YOUR FLYCAM SWIVEL...