Table of Contents
Advertisement
System Bootup Time
The UB‐E04 requires some bootup time for initializing the system after power‐on or system reset.
The network communication functions are unavailable during system bootup. The required bootup time is
as follows.
When setting the IP address in the Manual mode: Approximately 15 seconds
When setting the IP address automatically with the DHCP server: Approximately 20 seconds
(The value may vary, depending on the response time of the DHCP server.)
In case of after factory shipment or the initial bootup after the setting initialization, it may
take about 1 minute longer for the initial setting until the bootup
Supported TM Printers
The UB-E04 can be used in combination with the following TM printers.
TM-T88V, TM-T88IV, TM-T70II, TM-L90, TM-U220, TM-U330, TM-H6000IV, TM-H2000
Inquire with your dealer regarding new TM printers not listed above.
Environmental Specifications
Item
Operating Conditions
Temperature /
Storage Conditions
Humidity
(In shipping packaging)
Limitations
The UB-E04 has the following limitations. For limitations on TM printers, see Technical Reference Guides for
TM printers.
TM Printer Settings
• Set the printer receive buffer capacity to "Large".
Communication
• When printing a high volume of data such as graphics, the print speed may be slower.
• For cautions regarding wireless LAN communication, see
38
Specifications
0°C to 50°C {32°F to 122°F}, 10% to 90% RH non-condensing
-10°C to 50°C {14°F to 122°F}, 10% to 90% RH non-condensing
"Wireless LAN Connection" on page 5
.
.
Advertisement
Table of Contents
