Table of Contents
Advertisement
GoldStar
9
Working Programs:
The device has 2 program/working system.
1-GR: Ground Program
2-DLY: Delay Program
1-GR(Ground):When you press this button, DLY program closes, GR mode
opens. Hold for 2 seconds to see it on screen. If you only press, it help you to
change mode in gr1,gr2,gr3 and gold program. The working logic changes in
that program. For more mineralized soils, the mineral effect of the soil is
largely removed. Although depth losses occur in some metals compared to
the DLY Program, many metals do not change under the ground. It offers
very comfortable use. The coil is 50 cm. After resetting in the air, it is
brought to the ground. If there is no signal response when you raise the coil
and lower it to the ground, the device is set. The distance to the ground will
no longer be kept.
Delay has a ground effect, and is deeper than the ground
2-DLY(Delay):
program. You should keep a distance between ground and coil in Delay
program.
Take the distance between coil and ground as a reference when you reset
the device in Delay Program. Dont move it up or down when you reset.
When you move the coil down to ground, device gives increasing signal
sound. During the search, keep the device in constant height. In the given
factory settings, there is no problem in many soil structures with large
coils.In Gr program, small coils are used.
Delay has 5 stages. The more the delay, the more the depth of the small
metals. Not much change in depth for large metals. The higher the delay, the
higher the mineral effect.. Delay in 1,2,3 have less mineral effect and more
stability. It is largely abstracted from mineral and small metals.
If there are adjustment distortions in each different soil structure, a new
adjustment should be made in that soil structure by pressing the Zero
button.Delay3 is recommended.
Advertisement
Table of Contents
