Buttons - Goldstar GT18+ User Manual

GoldStar 7

Buttons;

Zero:
It is a button to reset. It is explained in detail in the other pages.
Delay:Transition to the Delay Program.
"Delay" is searched by setting a distance between the header and the
ground. In this program, the distance from the ground must be kept.
Large coils are used.
GR:Transition to Ground Balance Program. GND1,GND2,GND3 are
prefered accroding to state of the soil. Small coils are used generally in
that program.
So 38cm and 45cm coils are used in gnd mode, and large coils are used
in delay mode, 90cm coil is available for both delay and gnd mode.
LIGHT:
The button for setting the brightness of screen. It has 2 stages.
Zero ve Soil Setting:
Zero:
It resets the device. Also helpful to get rid of parasites.
ZERO in Delay Program:
You only need to press zero button once in DLY(delay) mode. You will see a
Zero text near to the battery icon. That means it is ready.Especially in delay
auto1 mode, if the signal balance is broken down, you only need to press
the Zero. In auto3 mode, it resets on its own, so you do not need to press
zero.
Searching Clicky sounds: Set up Auto1 in menu and below if you choose
tone 3 you will have clicky static sound. It only works in delay mode.
Program:Auto3 is recommended in that program.
ZERO in Ground(GR)
So you need to press zero if you want it to reset automatically.
ATTENTION! If the soil setting is not able to set up, the device is probably on a
metal..