Gr Program - Goldstar GT18+ User Manual

GoldStar 10
GR PROGRAM USAGE
First, 38cm and 45cm coils are recommended in GR1 program.
90cm coil can be used in both programs.
Large coil should be used in delay mode.
------------------------------------------------------------------------------------------
Usage of 38 , 45,90 cm. Coils in GR1 Mode:
Connect the battery and coil properly. The battery socket is on left, the coil socket is on the
right. After connecting the coil, make it tight by rotating it.
-Before turning on the device, the coil should be looking ahead.
-Hold the switch on button for 3 seconds.
-Wait. After the logo, the mainmenu will be on the screen..
-Now open GR1 mode by pressing GR Button.
-Set the device:AUTO3, SNS5, FİL3, TRS7.
-Soil setting button should be looking up.
If there is parasite, find the optimal frequency.
-
-Now you can lower the coil to the ground. If there is metal on the ground it will
give sound, so check if it gives sound/reaction on a ground where there is no
metal.
-If there is reaction, set the device: sns4 trs6.
-If there is No reaction, set the device: sns5,trs7.Now it is ready to use.
Movement for Coil:
Move the coil left and right slowly. When moving, the height should be parallel.
(Look the picture below)
When it detect a metal, it will give signal and on the screen, the signal will get high
so the bars will get high.