Table of Contents
Advertisement
GoldStar
12
Auto in Delay Program
Usage of AUTO 0,1,2 Static:
When the delay is in Auto 0.1.2, the bar image is displayed on the screen. In this case, 3 different
tones can be selected below tone option in the menu. The most preferred tone is 3. When the tone is
at 3, small changes on the ground are in the sound. It is presented with small changes in tone 1 and
2, and it becomes more sensitive.
AUTO3,4,5 Dynamic Zero
In Auto3, the bar screen is canceled and the sound is used completely. With
a different tone except 3 tones in the menu, the system with continuous
reseting is enabled. In other words, automatic ground reset, instant reset is
activated.
In this tone of voice, a more effective sound is produced in close targets,
while it gives a breathing sound in deep targets, while in waste metals,
especially many types of iron, small waste will give a double tone mixed
sound.
When you swing from four directions on the target, even one aspect of it
giving a doubled sound indicates that it is worthless. Although there are
sometimes mistakes, you will get rid of many unnecessary targets with the
right results. This will save both time and effort.
It will give a fuller breathing sound in precious bulk metals.
Auto4.5 resets faster but will increase its speed and slightly reduce the deep
signals. If the small coil is in a very waste environment, it will be
appropriate to auto.
Due to the importance of this issue, follow our training videos by
subscribing to our youtube channel.
Pinpointing
The method of averaging the target when you find a target is the + method.
In other words, it is to find the point where the strongest signal is received
by moving the head over the target from right and left to make a + on the
received signal.
Follow the signal strength on the screen; where the bars and the sound are
loudest is where you are directly above the metal.
Advertisement
Table of Contents
