Preperation Of Device - Goldstar GT18+ User Manual

GoldStar 6
Preperation the device to use:
1-Device Holder:They are located on both sides of the device. Make sure that
it is securely attached to the device by pulling in the geard side of the holder.
2-Battery Socket: Battery socket is on the left of the device.After connecting it right, hold it tight well.
ATTENTION:Do not try to connect it to the Coil Socket.
3-Coil Socket: Coil socket is on the right of the device. Wrap the connecting
cable of the coil around the handle and plug it into the socket on the right of
the device and tighten it well..
4-Coil selection switch:The direction of this switch should be changed when
using small header. When the direction of the switch is up, 38cm or 45cm
coil can be used. The direction of the switch should be down if you use big
coils such as 90cm or 120 cm. If you do this wrong, it can still work but there
will be soil influence, pay attention to this.
5-Switch on/off: You should press this button for 2-3 seconds to open after
connecting the battery. When you switch it off, you should press it for 4-5
seconds.
6-Screen Setting: After the device is switched on, if you cannot see anything
on the screen, you can use this button to set up the screen, and you will be
able to see characters on the screen.
7-Manual Soil Setting Button: This green button is for manually adjusting the
ground mineral on both delay and ground. Gr1 is recommended for small
headers and in this program, if the green button waits at 12 o'clock, it is in a
position to remove all minerals. In the 90cm headers, the depth of the group
money increases as you rotate button right in the gr1 mode. In 90cm headers,
as you turn this button right in gr1 mode, your group coin depth increases. In
the delay mode, as you turn it right, mineral removes, if there is no influence
on the soil, do not turn it right in delay mode..