Delay Program - Goldstar GT18+ User Manual

GoldStar 11
Usage of Delay Program:
If you want to work with screen bars, you could set Auto1.
Screen bars disappears in Auto3,4,5. You will only get sounds
and values.
Usage of DLY with 90 cm and 1,5x1,5 Coils:
-Connect 1,5x1,5 coil to the device before opening it. Set the key down which is on
the screen's right.
-Lift the coil up to waist level. Turn on the device.
-
Menu Setting:Delay3,Auto3,sens5,fil3,trs6 is recommended.
-Lower the coil to the ground approximately 20cm. And press Zero once.
-If we consider the average search distance as 20 cm, lower the coil to the ground
and lift it between 5 cm from the ground and observe if there is a ground effect.This
is very important. Do not make it touch the ground.
-if there is reaction, turn the soil setting button to the right a little bit. turn it right
until you get less reaction.
- When you set your coil, you can start using it by keeping the distance.
If you do not have ground effect while starting the first adjustment, you do not
need to turn the soil setting button.
Move slowly, take your time.
Change your frequency setting if there is unnecessary increase in magnetic
environments where parasite may be very high.. Or you can set your device:
AUTO3,DLY3,SNS5,FIL3,TRS5. It is normal to hear a slight sizzle/noise. Do
not take it serious. If you get a metal signal, get off the target and hold the
target from left to right again to make sure of the metal. The highest level of
the beep and signal bars is directly above the target. Real metal signals start
and end when the signal enters the target from all directions. During the
walking process, the target input signal must begin and end. If the signal
gets too long during the walking process, this may be caused by the mineral
structure that has a magnetic effect.