Parasite Causes And Solution - Goldstar GT18+ User Manual

GoldStar 17
Parasite causes and solutions
There are 2 reasons affecting all devices:
1-Electromagnetic waves around.
2. Magnetic and mineral effects of soil.
1-Electromagnetic waves around and Solution
Surrounding frequency effect produces interference to each device. Urban
environment, electrical wires, high voltages, transmitter stations, mobile phones near
the device generate these parasites. This is not a soil related parasite.
In order to prevent these interferences, precautions have been taken with the frequency
system in the device. If the device is constantly interfering with no movement, change
the frequency numbers in the FRQ setting. Because it is about the environment an the
field, we cannot say to set the frequency to any number. Find the number where the
noise is diminishing and leave it there. The frequency range is 30 stages. When we
turned on the device in our own office, there were parasites originating from the
indoor environment. The signal bars were increasing and decreasing. When we set the
frequency to 21 or 22, the parasite waves decreased.
Adjust your filter settings to 4, especially in urban environments near high voltages.
The parasite will drop.
2. Magnetic and mineral effects of soil.
It is impossible to completely get rid of the mineral and magnetic effects in the soil.
The two biggest problems in the soil in pulse devices are that the device is affected by
soil changes and dense tiles. The tiles show an iron mineral effect. Brick effect
increases even more especially in snowy and wet old ruins. Soil mineral effect
increases by working in snowy and wet soil. It is recommended to use in dry soil first.
The brick effect is low in large coils, like 1.5x1.5 and 2x2. Of course, this depends on
your setting. For example, in Delay 4.5, the brick effect increases. We recommend you
to visit the ruins at delay3. As a different method, delay3 auto3, sens4, trs6 could be
used. In this case, you should use a kite coil.
In highly mineralized places, it will be enough to turn the delay to 2 and turn the
ground adjustment button to the right.
-When using the Delay in auto1, if the setting is distorted due to soil change, press
ZERO button.
-Using headphones allows you to capture deep sounds that are useful for noisy
environments.
When using a large pipe coil, travel constantly with an experienced person who has the
skills to hold the coil.