Technique Of Excavation; Charging The Battery - Goldstar GT18+ User Manual

GoldStar 20
Excavation Technique:
1)While scanning with big coils, first the suspicous place is scanned. The
detected areas is indicated.
2)After this step, use the smaller coil, and change the mode to GR Program and
set the soil setting, and hold the coil over the indicated area. If you receive a
signal, take out the metal.
3)If you cant receive signal with small coils, it is probably in deeper. In this
case, excavate the area deeper. After excavating at least 50x50 average 30 cm,
hold the coil again. (In this step, you must use GR Program, we do not
recommend DLY program with small coils.)
4)If you cannot receive any signal with small coils, you should confirm by using
big coils. If the signal is not received, it could be mineral or brick pile.
If you receive stronger signals, repeat the steps above. You will get comfortable
with this as you use the device.

Charging the battery:

Gold technology takes care to use the best selection for battery and its adapter,
because battery and charger the causes that effect the performance. It is good to
use the adaptor of recommended company
The battery 12 voltage 7 Ah.
Remove the battery cable from the device and plug it into the outlet of the
charger. Make sure that the connector pins are correctly fitted. Let it charge until
the LED light turns green.
This may take 1-2 hours on average.
Charger 12 voltage battery