Table 5 Stratagy Dk System Configuration Parameters - Definitions And Settings - Toshiba Stratagy DK Manual

Press ESC.
3.
1;
Press
By
shutting down and restarting Stratagy, the changes take effect.
. ..or press
restarted. Until you restart Stratagy, the changes do not take effect.
. ..or press
3
4. Press
5. Press any key to reboot. The DOS prompt is displayed. To continue with Step 11, you
must re-enter Stratagy Admin.
Stratagy DK System Configuration Parameters - Definitions and Settings
Table 5
admingort
The following menu is displayed:
the changes are transmitted to Stratagy and Stratagy is shut down and restarted.
2;
the changes are transmitted to Stratagy but Stratagy is not shut down or
3;
the changes you have made are cancelled and not saved.
to save the changes. Stratagy shuts down and restarts.
In order for Stratagy to communicate with the portable/desktop computer connected to
one of its serial ports, Stratagy needs to know which port is to be used. This parameter
defines the logical port that Stratagy software uses Assignment of the logical port to the
physical port of the computer is made using the set serial-port parameter.
Example: Set this parameter to I for logical serial port 1
CAUTION! The connection may fail if the baud parameter for this port is set higher
than 960CJ or the serialport definitions for this porf do not correspond to the
definitions for the COM port being used on the portable/desktop computer.
Possible values:
1 (COMl), 2 (COM2)
Default: 2
Stratagy DK Installation Guide April 1997
Stratagy DK