Vivotek TS6346-EHL User Manual page 58

VIVOTEK
Exposure Profile: (Only available when the IR cut filter is not set to the Auto mode)
If you want to configure another sensor and exposure setting for an individual day/night/schedule mode,
please click Profile mode to open the Profile of exposure settings page as shown below.
Enable to apply these settings at: Select the mode this profile to apply to the Night mode or Schedule
mode. Please manually enter a range of time if you choose Schedule mode. Then check Save to take
effect.
Please follow the steps below to set up a profile:
1. Select the Enable to apply these settings at
checkbox.
2. Select the applicable Night mode or Schedule mode.
Please manually enter a range of time if you choose
Schedule mode.
When a span of time is configured using the Schedule
mode, you can configure the Day/Night setting for
controlling the behavior of the IR cut filter during that
time.
3. Configure Exposure control settings in the folowing
columns. Please refer to previous dicussions for
detailed information.
4. Click Save to enable the setting and click Close to exit
the window.
58 - User's Manual