Bush Hog BH200 Series Operator's Manual page 112

6. Hold driveline sections parallel to each other
and check for minimum 6" overlap. If driveline
has been marked for cutting, overlap will be the
distance between two marks. if driveline has
less than minimum overlap, do not use. Contact
authorized Bush Hog dealer.
NOTE: If driveline is the correct length, omit the
following steps 8 - 11 and proceed to step 12.
7. Clamp driveline in a well padded vice to prevent
damage to the shield. Cut off shield where
marked.
8. Using cut off section of shield as a guide, cut
shaft the same amount.
9. Repeat steps for other driveline section.
BH200 Series 08/20
© 2020 Alamo Group Inc.
OPERATION
Operation Section 4-16