Blade Removal - Bush Hog BH200 Series Operator's Manual

BLADE REMOVAL

Remove lockwasher and nut from blade bolt through inspection hole in deck of mower near the gearbox to
remove blades for sharpening or replacement. See Figure MntP-R-0057. Always replace lockwasher and nut
when replacing blade bolt. When installing blades be sure and check blade bolt pivot diameter for wear.
Replace bolt if worn more than 1/4 inch at any point. Tighten nut to 600 ft. lbs.
Avoid personal injury. Blade and/or blade carrier removal should be done only with the
tractor engine shut off, key removed, in neutral, parking brake on, PTO disengaged, and the
cutter blocked in the raised position.
BH200 Series 08/20
© 2020 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-10