Bush Hog BH200 Series Operator's Manual page 93

SETUP INSTRUCTIONS - SHIELDING AND DEFLECTORS
Bush Hog BH200 Series models as shipped from the factory have all Rear Shielding and Rear Deflectors in
place. Front Shielding and Front Deflectors have to be installed by the Dealer. Dealer should inspect to make
sure that all Safety Shielding and Deflectors are in place and fasteners are tight.
Front and Rear Deflectors or Front and Rear Chains are a selection on the BH200 Series
Models. One type of guard must be installed (and maintained in good repair) except for
agricultural purposes only in areas where persons, vehicles, livestock, or other property will
not be endangered by thrown objects and where such safety equipment would prevent the
mower's reasonable performance of its assigned agricultural task.
Deflectors: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and will
provide protection from thrown objects with proper operation under normal conditions. Deflectors must be
maintained in good repair or replaced after no more than two inches of wear off lower edge.
SETUP INSTRUCTIONS - TAILWHEEL
Bush Hog BH200 Series models as shipped from the factory Tailwheel Frame and Tailwheel mounted to
t h e u n i t . The Tailwheel will need to unbolted from two locations, removed, and rotated. Then, reinstalled.
When reinstalled, the bolt and bushing at the rear of the cutter will be used to mount the struts at the pivot
point of the Tailwheel tube as shown.
BH200 Series 08/20
© 2020 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-3