Meaning Of Symbols; Operating Sequence - EdilKamin LILLE 8 Up Installation - Use - Maintenance

Table of Contents

Advertisement

Dear Sir/Madam
We thank you for and congratulate you on choosing our
product. Before using it, we would ask you to read this
manual carefully, so that you can make the most of all its
functions in total safety.
This manual is an integral part of the product. We ask you
to keep it for the entire lifetime of the product. If you lose it,
you can request a copy from your dealer or download it from
www.edilkamin.com.
Readers of the manual
This manual is addressed to:
those who use the product at home ("USER");
the technician who will install the product ("INSTALLER")
The target person of each page is indicated in a band at the
bottom of the page (USER or INSTALLER).
General information
After unpacking the product, check the condition and
completeness of the contents.
In the event of error, immediately contact the retailer where
the purchase was made, providing him with a copy of the
warranty booklet and sales receipt.
The appliance must be installed and operated in compliance
with local and national law and European regulations. For the
installation, and for anything not specifically indicated in the
manual, observe local regulations.
The diagrams provided in this manual are for illustration
purposes only: they do not always strictly refer to your
specific model, and are not binding in any way.

MEANING OF SYMBOLS

In some parts of the manual the following symbols are
used:
PLEASE NOTE:
carefully read and understand the
message in question, since failure to
follow the instructions in it could cause
serious damage to the product and put
the safety of those using it at risk.
INFORMATION:
failure to comply with these requirements
will compromise product use.

OPERATING SEQUENCE:

follow the instructions for the operations
described.
Product identification and warranty.
The product is uniquely identified by a number, the
"counterfoil", which is indicated on the warranty certificate.
Please keep:
the warranty certificate accompanying the product
the purchase receipt given to you by the retailer
the declaration of conformity given to you by the installer.
The warranty conditions are given in the warranty certificate
accompanying the product.
The
warranty,
manufacturing defects and not, for instance, problems
resulting from improper installation or calibration.
CE marking
The product's CE marking plate is located on the back.
USER/INSTALLER
however,
covers
only
demonstrable
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

813580

Table of Contents