Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Equinox Systems LIGHTNING CRACKER 2
Summary of Contents for Equinox Systems LIGHTNING CRACKER 2
- Page 1 Order code: STRO20 User manual...
- Page 2 Equinox Lightning Cracker 2 Safety WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this...
- Page 3 Equinox Lightning Cracker 2 Safety IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! •...
- Page 4 0 - 9 (0=off, 9=high). DMX Mode To run the Lightning Cracker 2 Strobe in DMX mode, press the “MODE” button to show “ADD” on the LED display and set your DMX address using the “UP” and “DOWN” buttons from “000-512”.
- Page 5 DATA Cable (DMX cable) requirements (for DMX operation): • The Equinox Lightning Cracker 2 can be controlled via DMX-512 protocol. The DMX address is set on the back of the unit. Your unit and your DMX controller require a standard 3-pin XLR connector for data input/output (figure 1).
- Page 6 Equinox Lightning Cracker 2 DMX Set Up Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing.
- Page 7 Equinox Lightning Cracker 2 Notes...
Need help?
Do you have a question about the LIGHTNING CRACKER 2 and is the answer not in the manual?
Questions and answers