Kyocera KR2 User Manual page 33

Fragmentation Threshold
Wireless frames can be divided into smaller units (fragments) to improve performance in
the presence of RF interference and at the limits of RF coverage. Fragmentation will
occur when frame size in bytes is greater than the Fragmentation Threshold. This setting
should remain at its default value of 2346 bytes. Setting the Fragmentation value too low
may result in poor performance.
DTIM Interval
A DTIM is a countdown informing clients of the next window for listening to broadcast and
multicast messages. When the wireless router has buffered broadcast or multicast
messages for associated clients, it sends the next DTIM with a DTIM Interval value.
Wireless clients detect the beacons and awaken to receive the broadcast and multicast
messages. The default value is 1. Valid settings are between 1 and 255.
802.11d Enable
Enables 802.11d operation. 802.11d is a wireless specification for operation in additional
regulatory domains. This supplement to the 802.11 specifications defines the physical
layer requirements (channelization, hopping patterns, new values for current MIB
attributes, and other requirements to extend the operation of 802.11 WLANs to new
regulatory domains (countries). The current 802.11 standard defines operation in only a
few regulatory domains (countries). This supplement adds the requirements and
definitions necessary to allow 802.11 WLAN equipment to operate in markets not served
by the current standard. Enable this option if you are operating in one of these "additional
regulatory domains".
Wireless Isolation
Enabling Wireless Isolation prevents associated wireless clients from communicating with
each other.
WMM Enable
Enabling WMM can help control latency and jitter when transmitting multimedia content
over a wireless connection.
WDS Enable
When WDS is enabled, this access point functions as a wireless repeater and is able to
wirelessly communicate with other APs via WDS links. Note that WDS is incompatible
with WPA -- both features cannot be used at the same time. A WDS link is bidirectional;
so this AP must know the MAC Address (creates the WDS link) of the other AP, and the
other AP must have a WDS link back to this AP. Make sure the APs are configured with
same channel number.
WDS AP MAC Address
Specifies one-half of the WDS link. The other AP must also have the MAC address of this
AP to create the WDS link back to this AP. Enter a MAC address for each of the other
APs that you want to connect with WDS.
33 of 72