Kyocera KR2 User Manual page 3

BASIC HELP
•
Wizard
•
WAN
•
Network
•
DHCP
•
Wireless (Wi-Fi)
WIZARD
Setup Wizard
If you are new to networking and have never configured a router before, click on Setup
Wizard and the router will guide you through a few simple steps to get your network up
and running.
WAN
The WAN (Wide Area Network) section is where you configure your Cellular and Wired Internet
Connection type.
Cellular Modem PPP Authentication (optional)
Some cellular service providers require a username and password in order to connect
over PPP (Point to Point Protocol). In most cases, the default values provided by the
router will work and you should only change them if told to do so by your cellular service
provider.
Wired WAN Connection Type
There are several connection types to choose from: Static IP, DHCP, PPPoE, PPTP,
L2TP. If you are unsure of your connection method, please contact your Internet Service
Provider. Note: If using the PPPoE option, you will need to ensure that any PPPoE client
software on your computers is removed or disabled.
Static WAN Mode
Used when your ISP provides you a set IP address that does not change. The IP
information is manually entered in your IP configuration settings. You must enter the IP
address, Subnet Mask, and Gateway. Your ISP provides you with all of this information.
DHCP WAN Mode
A method of connection where the ISP assigns your IP address when your router
requests one from the ISP's server. Some ISP's require you to make some settings on
your side before your router can connect to the Internet.
Host Name: Some ISP's may check your computer's Host Name. The Host Name
identifies your system to the ISP's server. This way they know your computer is eligible to
receive an IP address. In other words, they know that you are paying for their service.
3 of 72