Summary of Contents for TEKTELIC Communications KONA ENTERPRISE T0007242
Page 1
May 20, 2021 PROPRIETARY: The information contained in this document is the property of TEKTELIC Communications Inc. Except as specifically authorized in writing by TEKTELIC, the holder of this document shall keep all information contained herein confidential, and shall protect the same in whole or in part from disclosure to all third parties.
Page 2
March 23, 2021 Draft Chathula Revision Adikary April 14, 2021 Draft H. Agus Revision April 19, 2021 Draft Updated power specification May 20, 2021 Released Updated T-Codes/Order Codes Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 2 of 15...
MOEN1LJP923 T0007435 Japan 920-928 MOEN1NNZ923 T0007422 New Zealand 915-928 MOEN1LNZ923 T0007435 New Zealand 915-928 Singapore, T0007422 MOEN1NSN923 Thailand, 920-925 Vietnam Singapore, T0007435 MOEN1LSN923 Thailand, 920-925 Vietnam Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 5 of 15...
Page 6
Figure 2 illustrates the Kona Enterprise Gateway external form-factor. All models share the same mechanical form-factor. Figure 1: Kona Enterprise Gateway Figure 2: Kona Enterprise Gateway Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 6 of 15...
Industry standard N-Type male Copper Ethernet RJ45 Modular Jack RJ45 modular plug followed by CAT 5e cable Earth Ground Compression lug Industry standard single-hole lug, M4 (#8) Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 7 of 15...
Conducted Immunity: EN 61000-4-6 Surge Immunity: EN 61000-4-5 Emissions: FCC pt. 15.109 Class B, FCC pt. 15.209, FCC pt. 15.247, EN 300 220, EN 301 489 Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 8 of 15...
(minimum 10W) 48V power supply with Hiccup Mode Current Limiting. • Always ensure the Ethernet connection port and 3G/4G Modem SIM card access port are properly sealed after installation or servicing. Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 9 of 15...
Figure 4. Slot 1 is for the secondary SIM (outer slot). Figure 4: SIM Tray Layout of Slot 0 and Slot 1 Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 10 of 15...
Kona Enterprise Gateway PoE must be mounted to a vertical pole or wall using the supplied mounting hardware which attaches to the back of the module as illustrated in 5. The vertical orientation is required for the GPS to function properly. Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 11 of 15...
Page 12
When mounted, the Gateway module must be oriented with the connector bulkhead pointed down towards earth as shown in Figure Figure 6: Kona Enterprise Gateway Module Wall Mounting Orientation Figure 7: Kona Enterprise Gateway Module Pole Mounting Accessories Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 12 of 15...
The ground cable installation steps are as follows: Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 13 of 15...
Note that the Cellular antenna port in not surge protected internal to the Gateway, an external surge suppressor such as Polyphaser p/n TSX-NFM or equivalent is recommended any time an external cellular antenna is connected. Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 14 of 15...
The Ethernet cable must have minimum 24 AWG conductors and shall be rated according to local and national electrical codes. Figure 10: Kona Enterprise Gateway Module Cable Gland Kona Enterprise Gateway T0007323_UG Version 1.3 TEKTELIC Communications Inc. Confidential Page 15 of 15...
Need help?
Do you have a question about the KONA ENTERPRISE T0007242 and is the answer not in the manual?
Questions and answers