Kyocera FS-1118 Operation Manual page 73

Message
Replace Toner.
Scan memory overflow. Job
is canceled.
Send error.
####
OPERATION GUIDE
Toner has run out so further copying or printing is
impossible.
Replace the toner container using a new toner kit.
Press right Select to cancel the copying procedure.
The total amount of data received by the machine
exceeds the machine's internal memory. To verify the
current amount of memory, print out a Status Page.
To cancel printing, press right Select. If Auto Error Clear
is set to On, printing will be automatically resumed after a
preset period of time.
Lower the image quality.
An error has occurred during transmission. The possible
error codes and their descriptions are as follows.
1101: The server name of the SMTP server is not set
correctly or the host name is incorrect when sending
scan data to an FTP server. Use COMMAND CENTER
and register the SMTP server name and the host name
correctly.
1102: The login user name is incorrect or the domain
name has not been entered. Enter login name, domain
name and password correctly.
1103: The network path name is incorrect or you do not
have access to the folder specified. Use COMMAND
CENTER and register the path name correctly.
1104: No recipient address. Enter e-mail address
correctly.
1105: E-mail - The SMTP protocol setting is turned off.
Use COMMAND CENTER and turn on the SMTP
protocol setting.
Scan to PC (SMB) - SMB setting is turned off. Use
COMMAND CENTER and turn on the SMB setting.
Scan to PC (FTP) - FTP setting is turned off. Use
COMMAND CENTER and turn on the FTP setting.
1106: The sender address setting under e-mail: SMTP is
not registered. Use COMMAND CENTER and register
the sender address.
210#: The network cable is disconnected or the hub that
it is connected to is not operating properly. Check the
cable connection or the hub.
The server name or the host name of the SMTP server is
not set correctly. Use COMMAND CENTER and register
the SMTP server name and the host name correctly.
220#: The network cable has become disconnected
during transmission or the hub that it is connected to has
stopped operating. Check the cable connection or the
hub.
Procedure
Troubleshooting
Reference
page 5-1
page 4-3,
Advanced
Operation
Guide
Advanced
Operation
Guide
page 4-11
Advanced
Operation
Guide
page 4-9
Advanced
Operation
Guide
Advanced
Operation
Guide
page 3-1
Advanced
Operation
Guide
page 3-1
6-5