Table of Contents
Advertisement
Section 5 Wireless EVO Configuration
5.0 Overview
The LightLEEDer EVO‐W wireless controller can connect to 64 relays and 64 LightSync input devices such as LSG3‐W
switches, photosensors, and wireless occupancy sensors. The LLEVO‐W controller can then be configured to control these
devices in the same manner as any ILC controller using the stand alone or network software.
The LLEVO‐W controller is equipped with a 900MHz radio with standard 50' line of sight range for communication with ILC
wireless devices. The devices cannot be "Direct Linked" when connected to a LLEVO‐W controller.
5.1 Recommended Procedure for Installation and Linking Devices to LLEVO‐W
1.
Install the wireless relay and connect to the load to be controlled.
2.
Test operation using relay Control/Link button to toggle the relay On/Off.
3.
Record the relays unique ID 8‐digit code for reference during programming.
4.
Install the LSG3‐W wireless switch, with the provided battery.
5.
Record the switch's unique ID 8‐digit code for reference during programming.
6.
Use the LightLEEder‐Pro Single Panel or Network Configuration Software to link devices.
5.2 Clear All Settings in the Relay's Direct Link Memory
*This will be needed if the relay has been previously direct linked.
1.
Hold the link button for 8 seconds or until the red and green LEDs flash alternately, and then
release the button to clear the memory.
5.3 LL‐Pro and LL‐Pro Network Configuration Software
The Software contains a wireless link control screen found under "Tools" for finding wireless devices and linking devices to the LLEVO‐W
panel, after this is completed the control mapping of the LS devices and relays is done in the same manner as with wired LightSync CAT‐5
devices and relays in a standard wired LLEVO panel.
Page 22 of 25
Advertisement
Table of Contents
