Lsg3-W Installation - Intelligent LLEVO-W Manual

3.4 LSG3‐W Installation
Installing the LSG3‐W Switch:

Install remote mount LightSync G3 Wireless switch within radio proximity of the wireless relay or LLEVO‐W
controller it will be linked to.

For best performance always mount the LSG3‐W switch where the radio is not obstructed by metal enclosures
or subject to equipment with high EMF radio noise. Plastic low voltage class‐2 enclosures or switch mounting
brackets are recommended if allowed by code, along with a plastic cover plate.

Mount LSG3‐W switch in standard 1‐gang switch bracket or junction box using screws provided.

Verify that the switch station is within 50 feet line of sight to the wireless relay or LLEVO‐W controller it is
intended to be linked to.

Before installing LSG3‐W switch, open battery door and install the provided battery. The wireless switch will
automatically enter link mode, refer to Technical Bulletin TB0401 for wireless relay direct link directions.

To link the LSG3‐W switch to a LLEVO‐W wireless controller refer to Technical Bulletin TB0402.
Page 19 of 25