Table of Contents
Advertisement
Section 4 Direct Link Control Operations
4.0 Overview
The Wireless Relays and LightSync switches can be Direct Linked to each other to operate as stand‐alone devices. When
direct linked the relay holds the link data and reads the switch type connected for internal mapping. Each wireless relay
can be linked to a maximum of 6 wireless devices, and 2 wireless photocells. Each LSG3‐W wireless switch station can
be linked to an unlimited number of wireless relays. When direct linked the devices can no longer be linked to a LLEVO‐
W panel for networking.
4.1 Recommended Procedure for Installation and Linking Devices
1. Install the wireless relay and connect to the load to be controlled.
2. Test operation using relay Control/Link button to toggle the relay ON/OFF.
3. Before installing the LSG3‐W wireless switch, refer to procedures below to
link the switch to the relay or relays to be controlled.
4. If the relay and switch have previously been linked, you will need to clear the link
settings in the relay's memory before proceeding, See section 4.5
4.2 Activate Direct Link Mode at a LSG3‐W Wireless Switch
1. Remove the battery and press any key to drain power, then re‐insert battery. The LSG3‐W switch
will stay in direct link mode for 10 minutes after battery power‐up. (Each wireless device transmits a
unique ID code to prevent overlapping signals)
4.3 Link WR5D, WR20D & WR20D‐EM Relay
1. Hold the relay link button for 3 seconds until the Green LED flashes and then release link button.
The green LED will remain ON and the relay will turn ON.
2. Press the button on the LSG3‐W switch for the desired Zone to be controlled.
The Relay will turn OFF and ON to indicate the link was accepted.
3. Press the button on additional LSG3‐W switches if needed.
4. Press the relays link button to exit relay linking mode, Green LED will turn OFF.
*The relays link mode times out after 16 seconds of non‐activity.
Page 20 of 25
Advertisement
Table of Contents
