Table of Contents
Advertisement
Section 3 LightLEEDer Wireless Product Installation
3.0 Overview
The LightLEEDer Wireless product use a 915MHz radio system for communication supporting a 50" line of sight
distance between devices. When installing always be aware of and avoid other equipment that may produce RF noise
that could interfere with the ILC radio communication. Do Not install the devices where a steel structure like ventilation
ducts may block or reduce signal strength. Always install the devices in an easy to access location.
3.1 LLEVO‐W Installation
Mount the remote LLEVO‐W wireless controller in an easy to access location,
typically, at the power junction box centrally located to the area to be controlled.
For best performance always place the LLEVO‐W where its radio is not obstructed by metal enclosures or
subject to equipment with high EMF noise.
Verify that the LLEVO‐W is within 50 feet line of sight to all switch stations
and relays intended to be linked to the controller.
Mount the LLEVO‐W to the junction box using the 1/2" nipple and secure the controller using the 1/2" locknut
provided and mounting bracket.
Terminate the line voltage lighting circuit 120 or 277VAC power leads to the controller as required by NEC
Code.
Run CAT‐5 data cable from the ILC panel network to the LLEVO‐W controller In/Out ports to add this controller
to the system.
Set the controller's unique address (2‐digit HEX) and record for future reference.
The LLEVO‐W can be programmed for stand‐alone or network operation from
the ILC network system, refer to LL‐Pro software instructions.
To link the LightLEEDer wireless relays and LightSync G3 wireless switches
to the LLEVO‐W controller refer to TB0402.
Page 15 of 25
Advertisement
Table of Contents
