Fitting The Additional Handle; Fitting/Changing The Roughing/Cutting Disc - Parkside PWSAP 40-Li A1 Original Instructions Manual

RISK OF INJURY!
► Note that when using the blade guard when
working with concrete or masonry, there may
be increased exposure to dust and a risk of
kickback.
► When using flange-mounted discs for a dual
purpose (combined grinding and cut-off
discs), use a blade guard suitable for abra-
sive cutting.
♦ Open the clamping lever a.
♦ Place the blade guard u with the coding
lug s in the coding groove d.
♦ Turn the blade guard u to the required position
(working position). The closed side of the blade
guard u must always be toward the operator.
♦ Close the clamping lever a to clamp the blade
guard u into position. If necessary, the clamping
force of the lock can be changed by loosening
or tightening the fine adjustment screw p.
Make sure that the blade guard u sits firmly
on the neck of the spindle.

Fitting the additional handle

CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle 8 fitted.
Failure to do so can lead to serious injury.
The additional handle 8 can be screwed
onto the left, the right or the top, depending
on the job at hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when changing
cutting/roughing discs.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit to the
mounting flange i without any play. Do not use a
reducer or adapter.
■ 12 │ GB │ IE
NOTE
► Use only discs which are free of dirt.
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button 9 only when the mounting spindle z is
at a complete standstill.
♦ Press the spindle locking button 9 to lock the
gearbox.
♦ Undo the clamping nut o using the two-hole
assembly spanner 7 (see fig. B).
♦ Place the roughing or cutting disc with the label
side towards the appliance on the mounting
flange i.
♦ Then replace the clamping nut o on the
mounting spindle z with the raised side facing
up.
With thin grinding discs (see fig. 1)
♦ The collar of the clamping nut o faces upwards
so that a thin grinding disc can be fitted safely.
Fig. 1
♦ Press the spindle locking button 9 to lock the
gearbox.
♦ Retighten the clamping nut o using the
two-hole assembly spanner 7.
With thick grinding discs (see fig. 2)
Fig. 2
The collar of the clamping nut o faces downwards
so that the grinding disk can be fitted securely onto
the mounting spindle z.
≤ 3,2 mm
12
> 3,2 mm
PWSAP 40-Li A1