Working Procedures - Parkside PWSAP 40-Li A1 Original Instructions Manual

Working procedures

NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding
Never use cutting discs
for rough grinding!
■
Move the angle grinder with moderate
pressure back and forth over the workpiece.
■ For soft material, move the roughing disc
at a flat angle over the workpiece; for hard
material at a slightly steeper angle.
Abrasive cutting
Never use roughing discs
for cutting!
■ Use only tested fibre-reinforced cutting
or grinding discs that are approved for a
peripheral speed of not less than 73 m/s.
CAUTION!
► The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■ Secure the workpiece. Use clamps/vices to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■ Always switch off the appliance before
putting it down and wait for the appliance
to come to a complete standstill.
■
Use the appliance only for dry cutting or
sanding.
■ The additional handle 8 must be fitted to the
appliance during all work.
■ Do not process materials containing asbestos.
Asbestos is a known carcinogen.
■ 10 │ GB │ IE
Tip! How to do things correctly.
DANGER! ALWAYS GUIDE THE
APPLIANCE THROUGH THE WORK-
PIECE IN REVERSE ROTATION.
► In the opposite direction there is a risk of a
kickback. The appliance can be pushed out
of the cut.
■ Always switch the appliance on before apply-
ing it to the workpiece. After completing the
task, lift the appliance from the workpiece and
then switch it off.
■
Always hold the tool firmly with two hands
while working. Ensure that your stance is
secure and stable.
■ For an optimum grinding effect, move the appli-
ance evenly at an angle of 15° to 30°
(between grinding disc and workpiece) back-
wards and forwards.
■ When working on angled surfaces, do not
exert too much force on the workpiece. If the
rotational speed drops significantly, you must
reduce the pressure exerted to allow safe and
effective working. If the appliance suddenly
brakes completely or jams, it must be switched
off immediately.
■ Cutting: Work at a moderate feed rate and
do not tilt the cutting disc.
■ Roughing and cutting discs become very
hot – let them cool down completely before
touching them.
■ Never use the appliance for purposes other
than the ones for which it was designed.
■ Always make sure that the appliance is
turned off before inserting the battery into it.
■ In the event of danger, turn off the appliance
immediately and remove the battery. Ensure
that the appliance is easily and quickly accessi-
ble in the event of an emergency.
■ Always remove the battery during work
breaks, when adjusting the appliance and
when it is not in use. The appliance must be
kept clean, dry and free of oil and grease at
all times.
PWSAP 40-Li A1