Advertisement
BASIC CONTROLS:
1) MENU - This button scrolls through the set parameters as indicated by the LED lamps to the left, in
the following order:
2) START will start the compressor, if no major faults are present (open pressure sensor, temperature
sensor, high temperature condition, or overload).
NOTE: The RUN STATUS LED will be ON to show that a start cycle is in progress. The compressor
will not start if the line pressure is above the load point; the compressor will start when the line pressure
drops below the load point. If the compressor is waiting to start, the 'Run Status' LED will flash rapidly.
(*These have no associated LED indicators)
3) STOP will initiate a controlled stop on the compressor. The stop cycle will take about 5 seconds to
complete. This is due to the system unloading and blowing down prior to stopping the motor.
4) UP and DOWN are used to select parameters in the setup menus.
5) RESET is used to clear a fault or service condition from the display panel.
NOTE: After a few minutes of inactivity, the control will return to the default display.
a) System Pressure (default)
b) Discharge Temperature
c) Running (Total) Hours; Shows 'run' followed by
the hours in alternating form.
d) Loaded Hours; Shows 'load' followed by the hours
in alternating form.
e) Separator Hours: 'SEPA', followed by the hours in
alternating form.
f) Air Filter Hours* shows 'AIr.f followed by the
hours in alternating form.
g) Fluid Filter Hours* shows 'Flu.f followed by the
hours in alternating form.
h) Fluid Service/Sample Hours; 'FLu' followed by the
hours in alternating form. (Total/Loaded LED)
2
Advertisement
