Advertisement
MENU 02: FILTER SERVICE HOURS
LED 1: This is the separator service hours setup. The display will show the hours remaining, alternating
with 'SEPA'. On servicing the separator, this counter is set to the desired service interval.
The LED's described above, will blink when the service intervals reach '00' in the main running display.
As before, the setting is 'saved' when the display reading is steady.
MENU 03: DISPLAY UNITS AND MODEL TYPE
LED 1: Selects the Pressure display in PSIG or BAR. Use the Up or Down keys to select.
LED 2: Selects the Temperature Display in 'F or 'C. Use the Up or Down keys to select.
LED 3: Selects Compressor Model: QSF or QSB/QMB. (Set at the Factory)
LED 4: Set the Running (Total) Hours. Use the Up or Down keys to select. (This should never be
adjusted except during controller replacement, to match recorded time from the previous one.)
LED 5: Sets the I.D. of the compressor. This may be used in a future network control option.
As before, the setting is 'saved' when the display reading is steady.
LED 2: This is the air filter service hours setup. The
display will show the hours remaining, alternating
with'AIr.F'. On servicing the air filter, this counter is
set to the desired service interval. An 'A' will blink at
the left side of the display on time-out.
LED 3: This is the fluid filter service hours setup.
The display will show the hours remaining, alternating
with 'FLu.F'. Use the UP or DOWN keys to adjust this
value to the desired range. An 'F' will blink at the left
side of the display on time-out.
LED 4: This is the fluid sample/service hours setup.
The display will show the hours remaining, alternating
with ' FLu'. On servicing the fluid filter or taking a
sample, this counter should be re-set to the desired
service interval.
4
Advertisement
