Enclosure - Schaudt EBL 263-5 Operating Instructions Manual

Operating Instruction Manual
Elektroblock EBL 263-5 Art no 911.056
* If due to overload the device gets too hot, eg charging an almost empty battery while all load is
switched on, battery charging will automatically be stopped. After cooling down the charging
module activates itself again. However, overheating should in any case be prevented.
* Should repairs be necessary, please contact the service department of Schaudt GmbH,
ph. +49 (0)7544 9577-16, e-mail: kundendienst@schaudt-gmbh.de
* If it is not possible to see the manufacturer for service (eg being overseas), necessary repairs can be
carried out by a qualified workshop.
* Unqualified repairs enforce expiration of warranty. The manufacturer Schaudt GmbH disclaims its
liability and is, therefore, not liable to resulting damages.
8.

Enclosure

To this operating instruction manual belongs the enclosed schematic diagram, the table of
measurement and front and back view drawings of the Elektroblock EBL 263-5, art no 911.056.
This operating instruction manual with all its enclosures must be delivered together with the energy
management system Elektroblock EBL 263-5, art no 911.056.
It has to be part of the instruction manual if it is part of a system installed in a motor home.
8.1 EC declaration of conformity
We hereby certify that the type of construction of Elektroblock EBL 263-5 complies with appropriate
regulations:
EC low-voltage guide line
Electromagnetic compatibility guide line
Applied standards and technical specifications,
particularly:
The EC declaration of conformity in original is available and can be looked at any time.
Manufacturer: Schaudt GmbH, Elektrotechnik & Apparatebau
Address: Daimlerstraße 5
88677 Markdorf
Germany
Note: this operating instruction manual is intended for the customer and has to be supplied with the device
Schaudt GmbH, Elektrotechnik & Apparatebau, Daimlerstraße 5, D-88677 Markdorf, Tel +49 7544 9577-0, Fax +49 7544 9577-29, www.schaudt-gmbh.de 18.05.2004
73/23/EWG amendment of 22.07.93
89/336/EWG amended to 92/31/EWG
DIN VDE 0700 part 1 /11.90 (EN 60335-1:1988)
DIN VDE 0700 part 29 /03.92 (EN 60335-2-29:1991)
DIN VDE 0551 T1 /09.89 (EN 60742:1989)
DIN EN 50081-1:3.1993
DIN EN 50082-1:3.1993
DIN EN 61000-3-2:2000
/
page 10 10