Table of Contents
Advertisement
8.
Release the ZIF connector (3) to which the audio/USB board cable is attached, and then
disconnect the audio/USB board cable from the system board.
9.
Remove the four Philllips PM2.4×4.6 screws that secure the system board to the base enclosure.
cad edit: need to replace system board screws
10.
Lift up on the right side of the system board (1) until it rests at an angle.
11.
Disconnect the power connector cable (2) from the system board.
56
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Advertisement
Table of Contents
