NETGEAR MBRN3000 User Manual page 31

2. On the router main menu, select Add a WPS Client, and then click Next. The following screen
displays:
Figure 2-4
By default, the Push Button (recommended) radio button is selected.
3. Either press the WPS button on the side of the router, or click the onscreen button.
The router tries to communicate with the client for 2 minutes.
4. Go to the client wireless computer, and run a WPS configuration utility. Follow the utility's
instructions to click a WPS button.
5. Go back to the router screen to check for a message.
The router WPS screen displays a message confirming that the client was added to the wireless
network. The router generates an SSID, and implements WPA/WPA2 wireless security. The
router will keep these wireless settings unless you change them, or you clear the Keep
Existing Wireless Settings check box in the WPS Settings screen.
Figure 2-5
6. Note the new SSID and WPA/WPA2 password for the wireless network. You can view these
settings in the Wireless Settings screen. See
on page 2-4.
Wireless Network Configuration
Mobile Broadband Wireless-N Router MBRN3000 User Manual
WPS button
"Manually Configuring Your Wireless Settings"
v1.0, October 2009
2-10