NETGEAR MBRN3000 User Manual page 28

Mobile Broadband Wireless-N Router MBRN3000 User Manual
4. Select the Authentication Type: Automatic, Open System, or Shared Key. The default is
Open System.
Note: The authentication scheme is separate from the data encryption. You can select
an authentication scheme that requires a shared key but still leaves the data
transmissions unencrypted. If you require strong security, use both the Shared
Key and WEP encryption settings.
5. Select the Encryption Strength setting:
• WEP (Wired Equivalent Privacy) 64-bit encryption. Enter 10 hexadecimal digits (any
combination of 0–9, a–f, or A–F).
• WEP (Wired Equivalent Privacy) 128-bit encryption. Enter 26 hexadecimal digits (any
combination of 0–9, a–f, or A–F).
6. Enter the encryption keys. You can manually or automatically program the four data
encryption keys. These values must be identical on all computers and Access Points in your
network:
• Passphrase. To use a passphrase to generate the keys, enter a passphrase, and click
Generate. This automatically creates the keys. Wireless stations must use the passphrase
or keys to access the router.
Note: Not all wireless adapters support passphrase key generation.
• Key 1-Key4. These values are not case-sensitive. You can manually enter the four data
encryption keys. These values must be identical on all computers and access points in your
network. Enter 10 hexadecimal digits (any combination of 0
7. Select which of the four keys will be the default.
Data transmissions are always encrypted using the default key. The other keys can be used
only to decrypt received data. The four entries are disabled if WPA-PSK or WPA
authentication is selected.
8. Click Apply to save your settings.
2-7
v1.0, October 2009
9, a f, or A F).
– – –
Wireless Network Configuration