NETGEAR MBRN3000 User Manual page 14

Mobile Broadband Wireless-N Router MBRN3000 User Manual
You can use the LEDs to verify status and connections. The following table lists and describes
each LED and button on the front panel of the router.
Table 1. LED and Front Panel Button Descriptions
LED LED Activity
Power Solid green
Solid Red
Off
Factory Reset
LAN Ports Solid green
1 - 4
Blinking green
Off
USB Off
Solid green
Blinking green
Internet Port Solid green
Solid red
Blinking green
Off
Wireless Solid green
Blinking green
Off
WPS Solid green
Blinking green
Off
Button
1-2
Description
Solid green. Power is supplied to the router.
POST (Power-On Self-Test) failure or device malfunction
Power is not supplied to the router
Lights momentarily when the Restore Factory Settings button is
pressed for 6 seconds, then blinks red three times when released. It
then turns green as the gateway resets to the factory defaults.
The Local port has detected an Ethernet link with a device.
Data is being transmitted or received.
No link is detected on this port.
• No USB device connected.
• "Safely Remove Hardware" has been activated.
• An error has occurred with the device.
USB device is ready to use.
USB device is in use.
There is an Internet session. If the session is dropped due to an idle
timeout, and an ADSL connection is still present, the light will remain
green. If the session is dropped for any other reason, the light will
turn off.
IP connection failed (no DHCP or PPPoE response, PPPoE
authentication failed).
Data is being transmitted over the ADSL port.
No Internet connection detected or device in bridged mode.
Indicates that the Wireless port is initialized.
Data is being transmitted or received over the wireless link.
The Wireless Access Point is turned off.
WPS wireless security is being enabled.
The device is in the 2-minute interval to synchronize security.
WPS is not being set or enabled.
Description
v1.0, October 2009
Configuring Your Router to the Internet