Software - Hitachi DZ-HS303A Service Manual

Adjustment > Creating Reference Data
Information:
The reference data is usually created once for each model because it is recorded on hard disk drive
(HDD) of PC with the adjustment software. However, creating reference data again is necessary in
the following cases:
a) When performing adjustment using a light box that is different from that used when the
reference data was created.
b) When performing maintenance of the light box used when creating the reference data
(replacing fl uorescent light, etc.).
c) When performing adjustment using a C12 light balancing fi lter that is different from that used
when the reference data was created.
d) When deleting the folder containing the adjustment software from HDD.
Restrictions:
If the same model with normal camera block as the one to be adjusted is not available, the
reference data can be created by the following procedure. However, reference data created this way
has been prepared at the factory, assuming the environment of service workplace, and may not be
suitable for all service workplaces. Therefore, it is recommended that you create reference data
using the same model with normal camera block as that to be adjusted.
1) Copy the adjustment software on HDD, referring to "6-1-6 Copying or Deleting Adjustment

Software".

2) Start up Explorer and open the refdata folder in map06w folder.
3) Refer to the following table to check the reference data fi le name of the model to be adjusted.
4) Copy the fi le with the same name as the reference data fi le name checked in step 3) in refdata
folder to map06w folder.
Model
DZ-HS303A
DZ-HS300A
Name of reference data fi le
gx3300.dat
bx35.dat
6 - 2