SRAM G2 RE Service Manual page 23

15 Insert the bleed block into the caliper. Insert the bleed block into the caliper.
You must bleed your brakes before reinstalling the brake pads.
Installing the brake pads prior to bleeding the brakes could
contaminate the brake pads and could lead to a brake failure.
16 Spray isopropyl alcohol on the caliper and clean it with a shop towel. Spray isopropyl alcohol on the caliper and clean it with a shop towel.
Visually check your work. If any of the o-rings protrude from the banjo fitting or banjo bolt, remove and replace the o-rings, then repeat the installation
process.
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions, visit www.sram.com/service.
⚠ WARNI NG
2011-2017 Code / Guide RE / G2 RE bleed block
⚠ CAUTION
23
Caliper Piston Installation