Configuration Using Code Symbols - Datalogic Gryphon D432E Reference Manual

4
4

CONFIGURATION USING CODE SYMBOLS

This section describes the programming method of using configuration code symbols
to program your reader. By using the Gryphon™ D432/D432E reader to read/decode
these special configuration symbols, you can configure, and obtain information from
its system software.
When you are
Gryphon™ D432/D432E 2D reader to avoid reading adjacent symbols.
The configuration code symbols in this chapter are divided into logical
sections according to the type of configuration required, (RS232 configuration,
Code selection, etc.). If arguments are required with a command, you can read
additional code labels (typically digits) from Appendix D.
To configure your reader:
1. Read the Enter Configuration code ONCE, available on top of each page.
2. Modify the desired parameters in one or more sections by reading the parameter
code and selecting the value from the Hex/Numeric table (see Appendix D) or by
following the given procedures.
3. Read the Exit and Save Configuration code ONCE, available on top of each
page.
Example for step 3:
To set the maximum length of characters in a Code 39 barcode symbol that the
reader will decode to 32:
•
first read the Maximum Length symbol for Code 39 on page 53
•
then read the symbol for the digit "3" and lastly the symbol for the digit "2" in
Appendix D.
16
reading configuration
GRYPHON™ D432/D432E
code symbols, carefully aim the