Creating Mobile Internet Wan Connection - D-Link DWR-921 User Manual

DWR-921 4G LTE Router
User Manual

Creating Mobile Internet WAN Connection

If the PIN code check is enabled for the SIM card inserted into the built-in LTE modem, for correct
operation of the mobile WAN connection click the ENTER PIN button in the notification in the top
right corner of the page and enter the PIN code in the window displayed. Then on the connection
creation page, in the General Settings section, select the relevant value from the Connection
type drop-down list and specify the needed values.
Figure 86. The page for creating a new Mobile Internet connection. The General Settings section.
Parameter
Connection name
Enable connection
Use as interface
NAT
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Move the switch to the right in order to create a network interface
for this connection, for example, to combine several interfaces into
a transparent connection.
If the switch is moved to the right, the network address translation
function for IPv4 is enabled. Do not disable the function unless your
ISP requires this.
The switch is displayed when the IPv4 or Dual value is selected
from the Type drop-down list in the Modem Settings section.
Page 100 of 255
Configuring via Web-based Interface
Description