Setting Up The Device; Connecting The Power Supply; Unwinding The Fm Wire Aerial - Silvercrest SPLB 44 A1 Quick Start Manual

Setting up the device

For safe and trouble-free operation of the device, the set-up location must fulfil
the following requirements:
♦ Place the device on a firm, flat and level surface.
♦ The surfaces of some items of furniture might contain components that can
corrode and soften the rubber feet of the device. If necessary, place a mat
under the device's rubber feet.
♦ Do not operate the device in a hot, wet or extremely damp environment.
♦ Keep a minimum distance of 30 cm to heat-emitting devices such as heaters,
ovens, etc.
♦ Operate the device only in locations with adequate ventilation.
♦ The mains socket must be easily accessible so that the plug can be easily
pulled out in an emergency.
♦ To achieve optimum sound, place the device on its side.

Connecting the power supply

CAUTION!
► Before connecting the device, compare the connection data (voltage and
frequency) on the device rating plate with that of your mains power supply.
This data must agree so that the device is not damaged.
♦ Make sure that the mains cable is
hot surfaces and/or sharp edges.
♦ Connect the plug of the mains cable
for the power supply on the rear of the device and plug the mains plug
into a mains socket. Ensure that the mains cable
♦ Route the mains cable
♦ Do not place the device, furniture or any other objects on the cable. Do not
kink the cable or knot it and do not connect it to other cables. Never wrap
the cable tightly around other objects otherwise the conductors inside the
cable could break and cause a malfunction.

Unwinding the FM wire aerial

♦ Completely unwind the FM wire aerial
device and route it so that you achieve optimum reception.
■ 34 │ GB │ IE
not damaged and is not routed over
to the mains connection socket
so that no one can stumble over it.
for FM reception on the rear of the
is not taut or kinked.
SPLB 44 A1