Liftmaster Internet Gateway (Not Provided); Erase All Codes; To Remove And Erase Monitored Entrapment Protection Devices; Constant Pressure Override (Cpo) - Chamberlain ELITE SL585UL Installation Manual

Ac slide gate operator

Hide thumbs Also See for ELITE SL585UL:

Wiring diagrams (2 pages)

Wiring diagrams (2 pages)

Wiring diagrams (2 pages)

Table Of Contents

Table of Contents

LiftMaster Internet Gateway (Not Provided)

To program the operator to the LiftMaster Internet Gateway:

Program using the learn button on the operator's control board:

1. Connect the ethernet cable to the LiftMaster Internet Gateway and the

router.

2. Connect power to the LiftMaster Internet Gateway.

3. Create an online account by visiting www.myliftmaster.com.

4. Register the LiftMaster Internet Gateway.

5. Use an internet enabled computer or smartphone to add devices. The

LiftMaster Internet Gateway will stay in learn mode for three minutes.

6. Press the Learn button twice on the primary operator (the operator

will beep as it enters learn mode). The LiftMaster Internet Gateway will

pair to the operator if it is within range and the operator will beep if

programming is successful.

The status as shown by the LiftMaster Internet Gateway app will be either "open" or "closed". The gate operator can then be controlled through the

LiftMaster Internet Gateway app.

Erase All Codes

1. Press and release the LEARN button (operator will beep and green XMITTER LED will light).

2. Press and hold the LEARN button again until the green XMITTER LED flashes and then release the button (approximately 6 seconds). All remote

control codes are now erased.

To Remove and Erase Monitored Entrapment Protection Devices

1. Remove the entrapment protection device wires from the terminal block.

2. Press and release the OPEN LEFT and OPEN RIGHT buttons simultaneously. The handing direction LED will remain solid. The other direction LED will

begin flashing (entering setup mode).

3. Press the OPEN LEFT and OPEN RIGHT buttons simultaneously to exit.

Constant Pressure Override (CPO)

Constant Pressure Override is for use with KPW5 and KPW250 keypads (not provided). The KPW5/KPW250 wireless commercial keypads are security

keypads and can only be programmed to ONE gate operator (see the KPW5/KPW250 manual for complete programming instructions).

The Constant Pressure Override feature is intended to temporarily override a fault in the entrapment protection system, in order to operate the gate until the

external entrapment protection device is realigned or repaired. Use the feature only in line of sight of the gate when no obstructions to travel are present.

External entrapment protection devices include LiftMaster monitored photoelectric sensors and LiftMaster monitored wired and wireless edge sensors. Be

sure to repair or replace these devices promptly if they are not working properly.

To use Constant Pressure Override:

1. Enter a valid 4-digit PIN.

2. Press and hold # for 5 seconds to enter CPO. Continue to hold # to keep the operator in motion. A continuous tone will sound until limit is met and/or

# is released.

3. The operator will stop when either the operator reaches a limit or the user releases #.

PROGRAMMING