Wolf Gas Range Surface Operation - Wolf R482CF Use & Care Information Manual

W O L F G A S R A N G E
S U R FAC E
A spark electrode ignites each surface burner.
This control eliminates the need for continuous
open flame pilots. For added safety and
convenience, each burner is designed with an
electronic reignition system. This feature
enables any burner to relight automatically in
the event it is accidentally extinguished.
Each surface burner provides a rating of 16,000
Btu/hr (4.7 kW) on HIGH with 500 Btu/hr
(.1 kW) delivered at simmer.
In case of a power outage, you can relight the
surface burners manually. Turn the control
knob to HIGH, then use a minimum 6" (152)
igniter to manually light the burner.
Manually relight each burner individually.
Do not try to manually relight the French
Top, charbroiler or griddle.
Manually relighting the burner
10
S U R FAC E O P E R AT I O N
B U R N E R S
Outer Burner
Ring
Center Cap
Igniter
Upper burner parts and alignment
B U R N E R A S S E M B LY
After cleaning or removing burner parts for
any reason, it is extremely important that you
reassemble the burners correctly. Refer to the
illustrations below for proper alignment of the
upper and base burner parts.
The center burner cap does not have a special
orientation but should be seated flat.
Failure to position the burner parts
correctly could cause flames or gas to
escape and burn between parts, resulting
in poor combustion or damage to your
gas range.
Igniter
Porcelain Top
Drip Pan
Burner Base
Base burner parts and alignment
Center Cap Cross
Ring