Wolf Gas Ranges - Wolf 30" (762) Installation Manual

Wolf Gas Ranges

Gas Range Installation
IMPORTANT NOTE: This installation must be completed
by a qualified installer, service agency or gas supplier.
Read this entire installation guide prior to installation and
save for the local inspector's reference. The homeowner
should keep this installation guide for future reference.
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedi-
cated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency, and amperage ratings are listed on the
product rating plate.
Wolf gas ranges are manufactured for use with natural gas
or LP gas. Check the product rating plate for the type of
gas for your specific model. If this appliance does not
correspond to your type of gas, contact your authorized
Wolf dealer.
Record the model and serial numbers before installing the
gas range. Both numbers are listed on the product rating
plate, located under the drip pan that supports the
cooking grates, inside the left side panel of the range.
Refer to the illustration below.
RATING PLATE
Location of rating plate
(inside panel).
Wolf Gas Range
Model Number
Serial Number
wolfappliance.com/specs
3