Contents Introduction Getting Started Overview Setup and Installation Making the Connections Solutions to Common Problems Technical Specifications Figures Figure 1: Transmitter to Receiver Connections Tables Table 1: T568B CAT 5 PINOUT Table 2: Technical Specifications of the Cobra DA9 Contents...
Distributor. The Kramer Cobra Series System extends video signals over ordinary CAT 5e cable. All models use a transmitter-to-receiver setup. This manual covers the Cobra DA9 1:9 CAT 5 Distributor. A Kramer Cobra transmitter unit as well as Kramer Cobra receiver units are required for operation.
(often associated with low quality cables) Avoiding interference from neighboring electrical appliances that may adversely influence signal quality and positioning your Cobra DA9 in a location free from moisture and away from excessive sunlight and dust Caution...
2. Connect RJ-45 cables from Cobra receiver units into the ports labeled OUTPUTS. 3. The port labeled UTP Loop may be used to cascade to other Cobra DA9 distribution amplifiers or can be used with a Cobra receiver. 4. Connect the power supply to the unit.
When using RS-232 transmitters or receivers in daisy chains, CAT 5 switches or Cobra DA , or Multi-output transmitters, the serial signal is a unidirectionally broadcast mode only. Solutions to Common Problems KRAMER: SIMPLE CREATIVE TECHNOLOGY...
1 Specifications are subject to change without notice Technical Specifications Table 1: T568B CAT 5 PINOUT of the Cobra DA9 Between transmitter and receiver(s): Category 5 shielded or unshielded twisted pair (STP or UTP) RGBHV, RGsB, composite (NTSC, PAL), component, HDTV, Y/C, YUV, s-video...
Page 9
For the latest information on our products and a list of Kramer distributors, visit our Web site: www.kramerelectronics.com, where updates to this user manual may be found. We welcome your questions, comments and feedback. Safety Warning: Disconnect the unit from the power supply before opening/servicing.
Need help?
Do you have a question about the Cobra DA9 and is the answer not in the manual?
Questions and answers