4.
Remove the solid-state drive (see
5.
Remove the WLAN module (see
6.
Remove the fan assembly (see
7.
Remove the heat sink assembly (see
Remove the system board:
1.
Disconnect the following cables from the system board:
●
●
●
●
●
●
●
●
2.
Remove the two Phillips M2.0 × 2.5 screws (1) from the USB bracket.
60
Chapter 5 Removal and replacement procedures for authorized service provider parts
Wireless antenna cables (1) from the WLAN module
Camera cable (ZIF) (2)
Display cable (3)
I/O board cable (4)
Backlight cable (ZIF) (5)
Keyboard cable (ZIF) (6)
Touchpad cable (ZIF) (7)
Speaker cable (8)
Solid-state drive on page
WLAN module on page
Fan on page
56).
Heat sink assembly on page
45).
50).
57).