Installation - Data Aire DAPA-2.5 Installation, Operation & Maintenance Manual

INSTALLATION

During installation, operation, maintenance or service, individuals may be exposed to certain
components or conditions including, but not limited to refrigerants, oils, and materials under pressure,
rotating components, and both high and low voltage. Each of these items has the potential, if misused
or handled improperly, to cause bodily injury or death. It is the obligation and responsibility of
operating/service personnel to identify and recognize these inherent hazards, protect themselves, and
proceed safely in completing their tasks. Failure to comply with any of these requirements could result
in serious damage to the equipment and the property in which it is situated, as well as severe personal
injury or death to themselves and people at the site.
This document is intended for use by owner authorized operating/service personnel. It is expected that
this individual possesses independent training that will enable them to perform their assigned tasks
properly and safely. It is essential that, prior to performing any task on this equipment, this individual
shall have read and understood this document and any referenced materials. This individual shall also
be familiar with and comply with all applicable governmental standards and regulations pertaining to
the task in question.
This manual contains important safety instructions that should be followed during the installation and
maintenance of Data Aire equipment. Read this manual thoroughly before attempting to install or
operate this unit.
Only qualified personnel should move, install or service this equipment. Adhere to all warnings, cautions
and installation, operating and safety instructions on the unit and in this manual. Follow all operating
and user instructions.
NOTICE: There is no intent on the part of Data Aire, Inc. to define local codes
or statutes which may supersede common trade practices. The manufacturer
assumes no responsibility for their interpretation. Consult local building codes
and National Electrical Code (NEC) for special installation requirements.
WARNING: Risk of handling heavy and lengthy parts, risk of top heavy
unit falling over, risk of sharp edges, splinters and exposed fasteners; can
cause personal injury and equipment damage. Cabinet doors and panels
can weigh more than 35lb. (15.9kg) therefore follow relevant OSHA lifting
recommendations and consider using a two person lift for safe and
comfortable removal and installation of cabinet doors and panels.
Only properly trained and qualified personnel wearing appropriate safety
headgear, gloves and shoes should attempt to remove or install cabinet
doors and panels.
11