Formula MOD Operating Manual page 8

If MOD shock is not already supplied on the bicycle, it's necessary check the frame
compatibility:
1) Remove the spring from the shock as written in paragraph "e";
2) Install the Formula hardware on the shock as written in paragraph "b" according to
the specific measures of the frame;
3) Insert MOD shock into the frame and tighten the screws of it (figure F).
4) Slowly Compress and extend the rear part of the frame making the whole stroke.
Inspect if there is interference with the frame (figure G);
5) Remove the shock from the frame;
6) Install the spring with the correct preload as showed in paragraph "e" and install
MOD shock.
End procedure
8
Fig. F Fig. G