Formula MOD Operating Manual page 5

ENVIRONMENTAL NOTES
In order to protect the environment, please follow these simple instructions to
correctly dispose of FORMULA S.a.S products:
1) The packaging does not require special disposal because it is not dangerous in any
way; we suggest recycling paper and plastic.
2) It is also recommended to recycle the metal parts after use.
For both points mentioned above, it is recommended to dispose of the waste following
national regulations through the appropriate specialized waste disposal companies.
INDEX:
1.1 Formula hardware installation;
1.2 Installing shocks on a MTB frame;
1.3 SAG and Adjustments;
1.4 Hydraulic regulation:
1.4.1 Rebound;
1.4.2 Compression;
1.4.3 Lockout;
1.5 CTS (compression tuning system) replacement;
1.6 Spring replacement;
1.7 Maintenance intervals
1.8 Formula spacer for reduction stroke
1.9 Problems - Causes - Remedies
1.1 Formula hardware installation:
Formula hardware kit may differ depending on the customer's request regarding its
frame. The bushings (DU) are already installed on the rear shock absorber.
For STANDARD attack shocks, the kit includes (figure A):
a) n.2 assembly pins;
b) n.4 spacers;
c) n.4 Orings;
For TRUNNION shocks:
a) n.1 mounting pin;
b) n.2 spacers;
c) n.2 Orings.
ATTENTION: The screws for the TRUNNION connection are supplied by the
frame manufacturer. FORMULA assumes no responsibility for damage or mal-
functions due to the condition of these screws.
Fig. A
5